This high-powered 2000W e-bike rear hub motor kit is a significant upgrade from standard pre built street legal options. It delivers more torque and a higher top speed, while still being compatible with most bikes that have a 135mm dropout width. This kit is intended for off-road use only, so be sure to check your local laws and regulations before making a purchase.
PACKAGE CONTENTS
- 1 x 2000W brushless direct-drive (gearless) rear hub motor
- 1 x 45A brushless motor controller with an XT60 connector for the battery
- 1 x LCD SW900 display or UKC1
- 1 x Pedal Assist Crank Sensor (PAS)
- 1x 52v 25ah 50amp Battery
- 10x Battery Straps
- 1x 58.8v 3amp Charger
- 1 x Right-Hand Throttle (full twist) with a matching left-hand handlebar grip
- 1 x Pair of Brake Levers (compatible with mechanical/cable brakes)
DESCRIPTION
This kit offers more power than standard models, with a top speed of up to 70km/h. Ensure you comply with your local laws by setting the speed limiter to 25km/h and 250W when riding in public areas. Only generic instructions are provided due to the many DIY possibilities, but assistance is available if needed DM on instagram.
KEY FEATURES
-
Wheel Type: Rear Wheel
-
Battery Connecter: XT60
-
Battery Charge Plug: AUS,UK,USA
-
Range: 70km for 2000w
-
Dropout: 135mm (fits most bikes, not compatible with thru axles)
-
Wheel Size: 26", 27.5", or 29"
-
Rim: Alloy double-wall with a 33mm internal width
-
Gears: Freewheel / screw-on (not compatible with cassette)
-
Motor: Brushless DC direct drive
-
Torque: 55 Nm
-
Power: 2000W
-
Max Speed: 70-75km/h
-
Spokes: Steel 12Gx2.6mm
-
Weight: 6 kg
-
Wheel Axle: 210mm x 10mm
-
Max Load Capacity: 150kg (including bike and rider)
WARRANTY
- General wear and tear is not covered.
- Damages caused by improper installation are not covered. Please contact us if unsure about fitting or operating the kit.
- Ensure proper alignment and protection of the wiring from the motor axle to avoid damage, which is not covered under warranty.
- Ensure the motor axle is fully seated in the bike’s dropouts and the 21mm axle nuts are tightened securely. Damage from improper installation is not covered.
- When operating in full power mode, fitting a torque arm (sold separately) on both sides is highly recommended to prevent the axle from spinning within the dropouts, which could damage the wiring. This damage is not covered by warranty.
- The kit is not waterproof and should not be submerged in water.
- A 2-week warranty is provided from the date of receipt.
- While this kit is known for durability, misuse, including jumps, impacts with curbs, exceeding the weight limit, or downhill riding, is not covered by warranty. The kit is best suited for smooth surfaces and light gravel paths.
NOTES
- Press the 'M' button on the LCD display to power on and unlock the full potential of the kit.
- Australian regulations require that the kit be limited to 250W and 25km/h on public roads. To comply, adjust the 'P08' setting to 25km/h in the LCD display. Hold the ‘UP’ and ‘DOWN’ buttons for 1 second after powering on the kit, then short-press ‘M’ to navigate through the ‘P’ settings until reaching 'P08.'
NOT INCLUDED
torque arms, installation tools, freewheel gear, specific instructions, and disc brakes.
