This high-powered 2000W e-bike rear hub motor kit is a significant upgrade from standard pre-built street-legal options. It offers increased torque and a higher top speed while still being compatible with most bikes featuring a 135mm dropout width. Make sure to review your local laws and regulations before purchasing.
PACKAGE CONTENTS
1 x 2000W brushless direct-drive (gearless) rear hub motor
1 x 50A brushless motor controller with an XT60 connector for the battery
1 x LCD SW900 display or UKC1
1 x Pedal Assist Crank Sensor (PAS)
1 x Right-Hand Throttle (full twist) with a matching left-hand handlebar grip
1 x Pair of Brake Levers (compatible with mechanical/cable brakes)
1x 52v 20ah 50amp Battery
1x 3amp 58.8v Charger
10x Battery Straps
DESCRIPTION
This kit provides more power than standard models, with a top speed of 70-75km/h. Be sure to comply with local laws by setting the speed limiter to 25km/h and 250W when riding in public areas. Generic instructions are included, but if you need help, feel free to DM us on Instagram for support.
KEY FEATURES
Wheel Type: Rear Wheel
Battery Connector: XT60
Battery Charge Plug: AUS, UK, USA
Range: 50km for 2000W
Dropout: 135mm (fits most bikes, not compatible with thru axles)
Wheel Size: 26", 27.5", or 29"
Rim: Alloy double-wall with a 33mm internal width
Gears: Freewheel / screw-on (not compatible with cassette)
Motor: Brushless DC direct drive
Torque: 60 Nm
Power: 2000W
Max Speed: 70-75km/h
Spokes: Steel 12Gx2.6mm
Weight: 6 kg
Wheel Axle: 210mm x 10mm
Max Load Capacity: 150kg (including bike and rider)
WARRANTY
General wear and tear is not covered.
Damages caused by improper installation are not covered. Please contact us if unsure about fitting or operating the kit.
Ensure proper alignment and protection of the wiring from the motor axle to avoid damage, which is not covered under warranty.
Ensure the motor axle is fully seated in the bike’s dropouts, and the 21mm axle nuts are tightened securely. Damage from improper installation is not covered.
When operating, fitting a torque arm (sold separately) on both sides is highly recommended to prevent the axle from spinning within the dropouts, which could damage the wiring. This damage is not covered by warranty.
The kit is not waterproof and should not be submerged in water.
A 2-Week warranty is provided from the date of receipt.
While this kit is known for durability, misuse, including jumps, impacts with curbs, exceeding the weight limit, or downhill riding, is not covered by warranty. The kit is best suited for smooth surfaces and light gravel paths.
NOTES
Press the 'M' button on the LCD display to power on and unlock the full potential of the kit.
Australian regulations require that the kit be limited to 250W and 25km/h on public roads. To comply, adjust the 'P08' setting to 25km/h in the LCD display. Hold the ‘UP’ and ‘DOWN’ buttons for 1 second after powering on the kit, then short-press ‘M’ to navigate through the ‘P’ settings until reaching 'P08.'
NOT INCLUDED
Torque arms, installation tools, freewheel gear, specific instructions, and disc brakes.
